CVSS: -EPSS: 0%CPEs: 3EXPL: 0CVE-2024-27057 – ASoC: SOF: ipc4-pcm: Workaround for crashed firmware on system suspend
https://notcve.org/view.php?id=CVE-2024-27057
In the Linux kernel, the following vulnerability has been resolved: ASoC: SOF: ipc4-pcm: Workaround for crashed firmware on system suspend When the system is suspended while audio is active, the sof_ipc4_pcm_hw_free() is invoked to reset the pipelines since during suspend the DSP is turned off, streams will be re-started after resume. If the firmware crashes during while audio is running (or when we reset the stream before suspend) then the sof_ipc4_set_multi_pipeline_state() will fail with IPC error and the state change is interrupted. This will cause misalignment between the kernel and firmware state on next DSP boot resulting errors returned by firmware for IPC messages, eventually failing the audio resume. On stream close the errors are ignored so the kernel state will be corrected on the next DSP boot, so the second boot after the DSP panic. If sof_ipc4_trigger_pipelines() is called from sof_ipc4_pcm_hw_free() then state parameter is SOF_IPC4_PIPE_RESET and only in this case. Treat a forced pipeline reset similarly to how we treat a pcm_free by ignoring error on state sending to allow the kernel's state to be consistent with the state the firmware will have after the next boot. En el kernel de Linux, se resolvió la siguiente vulnerabilidad: ASoC: SOF: ipc4-pcm: workaround para firmware bloqueado en suspensión del sistema Cuando el sistema se suspende mientras el audio está activo, se invoca sof_ipc4_pcm_hw_free() para restablecer las canalizaciones desde durante la suspensión el DSP está apagado, las transmisiones se reiniciarán después de reanudarse. Si el firmware falla mientras se ejecuta el audio (o cuando reiniciamos la transmisión antes de suspenderla), entonces sof_ipc4_set_multi_pipeline_state() fallará con un error de IPC y se interrumpirá el cambio de estado. Esto provocará una desalineación entre el estado del kernel y del firmware en el siguiente arranque del DSP, lo que provocará errores devueltos por el firmware para los mensajes IPC, lo que eventualmente provocará un error en la reanudación del audio. Al cerrar la transmisión, los errores se ignoran, por lo que el estado del kernel se corregirá en el siguiente inicio del DSP, es decir, en el segundo inicio después del pánico del DSP. • https://git.kernel.org/stable/c/3cac6eebea9b4bc5f041e157e45c76e212ad6759 https://git.kernel.org/stable/c/d153e8b154f9746ac969c85a4e6474760453647c https://git.kernel.org/stable/c/c40aad7c81e5fba34b70123ed7ce3397fa62a4d2 •
CVSS: 5.5EPSS: 0%CPEs: 2EXPL: 0CVE-2024-27056 – wifi: iwlwifi: mvm: ensure offloading TID queue exists
https://notcve.org/view.php?id=CVE-2024-27056
In the Linux kernel, the following vulnerability has been resolved: wifi: iwlwifi: mvm: ensure offloading TID queue exists The resume code path assumes that the TX queue for the offloading TID has been configured. At resume time it then tries to sync the write pointer as it may have been updated by the firmware. In the unusual event that no packets have been send on TID 0, the queue will not have been allocated and this causes a crash. Fix this by ensuring the queue exist at suspend time. En el kernel de Linux, se ha resuelto la siguiente vulnerabilidad: wifi: iwlwifi: mvm: asegúrese de que exista la cola de descarga TID La ruta del código de reanudación supone que se ha configurado la cola de TX para la descarga de TID. En el momento de la reanudación, intenta sincronizar el puntero de escritura, ya que es posible que el firmware lo haya actualizado. • https://git.kernel.org/stable/c/ed35a509390ef4011ea2226da5dd6f62b73873b5 https://git.kernel.org/stable/c/78f65fbf421a61894c14a1b91fe2fb4437b3fe5f https://access.redhat.com/security/cve/CVE-2024-27056 https://bugzilla.redhat.com/show_bug.cgi?id=2278409 •
CVSS: -EPSS: 0%CPEs: 5EXPL: 0CVE-2024-26996 – usb: gadget: f_ncm: Fix UAF ncm object at re-bind after usb ep transport error
https://notcve.org/view.php?id=CVE-2024-26996
In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_ncm: Fix UAF ncm object at re-bind after usb ep transport error When ncm function is working and then stop usb0 interface for link down, eth_stop() is called. At this piont, accidentally if usb transport error should happen in usb_ep_enable(), 'in_ep' and/or 'out_ep' may not be enabled. After that, ncm_disable() is called to disable for ncm unbind but gether_disconnect() is never called since 'in_ep' is not enabled. As the result, ncm object is released in ncm unbind but 'dev->port_usb' associated to 'ncm->port' is not NULL. And when ncm bind again to recover netdev, ncm object is reallocated but usb0 interface is already associated to previous released ncm object. Therefore, once usb0 interface is up and eth_start_xmit() is called, released ncm object is dereferrenced and it might cause use-after-free memory. [function unlink via configfs] usb0: eth_stop dev->port_usb=ffffff9b179c3200 --> error happens in usb_ep_enable(). NCM: ncm_disable: ncm=ffffff9b179c3200 --> no gether_disconnect() since ncm->port.in_ep->enabled is false. NCM: ncm_unbind: ncm unbind ncm=ffffff9b179c3200 NCM: ncm_free: ncm free ncm=ffffff9b179c3200 <-- released ncm [function link via configfs] NCM: ncm_alloc: ncm alloc ncm=ffffff9ac4f8a000 NCM: ncm_bind: ncm bind ncm=ffffff9ac4f8a000 NCM: ncm_set_alt: ncm=ffffff9ac4f8a000 alt=0 usb0: eth_open dev->port_usb=ffffff9b179c3200 <-- previous released ncm usb0: eth_start dev->port_usb=ffffff9b179c3200 <-- eth_start_xmit() --> dev->wrap() Unable to handle kernel paging request at virtual address dead00000000014f This patch addresses the issue by checking if 'ncm->netdev' is not NULL at ncm_disable() to call gether_disconnect() to deassociate 'dev->port_usb'. It's more reasonable to check 'ncm->netdev' to call gether_connect/disconnect rather than check 'ncm->port.in_ep->enabled' since it might not be enabled but the gether connection might be established. En el kernel de Linux, se ha resuelto la siguiente vulnerabilidad: usb: gadget: f_ncm: corrige el objeto UAF ncm al volver a vincularlo después del error de transporte usb ep Cuando la función ncm está funcionando y luego detiene la interfaz usb0 para desconectar el enlace, se llama a eth_stop() . En este punto, accidentalmente, si ocurre un error de transporte USB en usb_ep_enable(), es posible que 'in_ep' y/o 'out_ep' no estén habilitados. Después de eso, se llama a ncm_disable() para deshabilitar ncm unbind, pero nunca se llama a gether_disconnect() ya que 'in_ep' no está habilitado. • https://git.kernel.org/stable/c/7f67c2020cb08499c400abf0fc32c65e4d9a09ca https://git.kernel.org/stable/c/0588bbbd718a8130b98c54518f1e0b569ce60a93 https://git.kernel.org/stable/c/f356fd0cbd9c9cbd0854657a80d1608d0d732db3 https://git.kernel.org/stable/c/7250326cbb1f4f90391ac511a126b936cefb5bb7 https://git.kernel.org/stable/c/6334b8e4553cc69f51e383c9de545082213d785e •
CVSS: 5.5EPSS: 0%CPEs: 3EXPL: 0CVE-2024-26982 – Squashfs: check the inode number is not the invalid value of zero
https://notcve.org/view.php?id=CVE-2024-26982
In the Linux kernel, the following vulnerability has been resolved: Squashfs: check the inode number is not the invalid value of zero Syskiller has produced an out of bounds access in fill_meta_index(). That out of bounds access is ultimately caused because the inode has an inode number with the invalid value of zero, which was not checked. The reason this causes the out of bounds access is due to following sequence of events: 1. Fill_meta_index() is called to allocate (via empty_meta_index()) and fill a metadata index. It however suffers a data read error and aborts, invalidating the newly returned empty metadata index. It does this by setting the inode number of the index to zero, which means unused (zero is not a valid inode number). 2. When fill_meta_index() is subsequently called again on another read operation, locate_meta_index() returns the previous index because it matches the inode number of 0. Because this index has been returned it is expected to have been filled, and because it hasn't been, an out of bounds access is performed. This patch adds a sanity check which checks that the inode number is not zero when the inode is created and returns -EINVAL if it is. [phillip@squashfs.org.uk: whitespace fix] Link: https://lkml.kernel.org/r/20240409204723.446925-1-phillip@squashfs.org.uk En el kernel de Linux se ha resuelto la siguiente vulnerabilidad: Squashfs: comprobar que el número de inodo no sea el valor no válido de cero. • https://git.kernel.org/stable/c/be383effaee3d89034f0828038f95065b518772e https://git.kernel.org/stable/c/7def00ebc9f2d6a581ddf46ce4541f84a10680e5 https://git.kernel.org/stable/c/9253c54e01b6505d348afbc02abaa4d9f8a01395 https://access.redhat.com/security/cve/CVE-2024-26982 https://bugzilla.redhat.com/show_bug.cgi?id=2278337 •
CVSS: -EPSS: 0%CPEs: 5EXPL: 0CVE-2024-26980 – ksmbd: fix slab-out-of-bounds in smb2_allocate_rsp_buf
https://notcve.org/view.php?id=CVE-2024-26980
In the Linux kernel, the following vulnerability has been resolved: ksmbd: fix slab-out-of-bounds in smb2_allocate_rsp_buf If ->ProtocolId is SMB2_TRANSFORM_PROTO_NUM, smb2 request size validation could be skipped. if request size is smaller than sizeof(struct smb2_query_info_req), slab-out-of-bounds read can happen in smb2_allocate_rsp_buf(). This patch allocate response buffer after decrypting transform request. smb3_decrypt_req() will validate transform request size and avoid slab-out-of-bound in smb2_allocate_rsp_buf(). En el kernel de Linux, se resolvió la siguiente vulnerabilidad: ksmbd: corrige slab-out-of-bounds en smb2_allocate_rsp_buf Si ->ProtocolId es SMB2_TRANSFORM_PROTO_NUM, se podría omitir la validación del tamaño de la solicitud smb2. Si el tamaño de la solicitud es menor que sizeof (struct smb2_query_info_req), la lectura de losa fuera de los límites puede ocurrir en smb2_allocate_rsp_buf(). Este parche asigna un búfer de respuesta después de descifrar la solicitud de transformación. smb3_decrypt_req() validará el tamaño de la solicitud de transformación y evitará la losa fuera de los límites en smb2_allocate_rsp_buf(). • https://git.kernel.org/stable/c/da21401372607c49972ea87a6edaafb36a17c325 https://git.kernel.org/stable/c/b80ba648714e6d790d69610cf14656be222d0248 https://git.kernel.org/stable/c/3160d9734453a40db248487f8204830879c207f1 https://git.kernel.org/stable/c/0977f89722eceba165700ea384f075143f012085 https://git.kernel.org/stable/c/c119f4ede3fa90a9463f50831761c28f989bfb20 •