CVSS: 6.5EPSS: 0%CPEs: 154EXPL: 0CVE-2023-22404 – Junos OS: SRX Series and MX Series with SPC3: When IPsec VPN is configured iked will core when a specifically formatted payload is received
https://notcve.org/view.php?id=CVE-2023-22404
An Out-of-bounds Write vulnerability in the Internet Key Exchange Protocol daemon (iked) of Juniper Networks Junos OS on SRX series and MX with SPC3 allows an authenticated, network-based attacker to cause a Denial of Service (DoS). iked will crash and restart, and the tunnel will not come up when a peer sends a specifically formatted payload during the negotiation. This will impact other IKE negotiations happening at the same time. Continued receipt of this specifically formatted payload will lead to continuous crashing of iked and thereby the inability for any IKE negotiations to take place. Note that this payload is only processed after the authentication has successfully completed. So the issue can only be exploited by an attacker who can successfully authenticate. • https://kb.juniper.net/JSA70200 • CWE-787: Out-of-bounds Write •
CVSS: 7.5EPSS: 0%CPEs: 63EXPL: 0CVE-2023-22408 – Junos OS: SRX 5000 Series: Upon processing of a specific SIP packet an FPC can crash
https://notcve.org/view.php?id=CVE-2023-22408
An Improper Validation of Array Index vulnerability in the SIP ALG of Juniper Networks Junos OS on SRX 5000 Series allows a network-based, unauthenticated attacker to cause a Denial of Service (DoS). When an attacker sends an SIP packets with a malformed SDP field then the SIP ALG can not process it which will lead to an FPC crash and restart. Continued receipt of these specific packets will lead to a sustained Denial of Service. This issue can only occur when both below mentioned conditions are fulfilled: 1. Call distribution needs to be enabled: [security alg sip enable-call-distribution] 2. • https://kb.juniper.net/JSA70204 • CWE-129: Improper Validation of Array Index •
CVSS: 7.5EPSS: 0%CPEs: 133EXPL: 0CVE-2023-22417 – Junos OS: SRX Series: A memory leak might be observed in IPsec VPN scenario leading to an FPC crash
https://notcve.org/view.php?id=CVE-2023-22417
A Missing Release of Memory after Effective Lifetime vulnerability in the Flow Processing Daemon (flowd) of Juniper Networks Junos OS allows a network-based, unauthenticated attacker to cause a Denial of Service (DoS). In an IPsec VPN environment, a memory leak will be seen if a DH or ECDH group is configured. Eventually the flowd process will crash and restart. This issue affects Juniper Networks Junos OS on SRX Series: All versions prior to 19.3R3-S7; 19.4 versions prior to 19.4R2-S8, 19.4R3-S10; 20.2 versions prior to 20.2R3-S6; 20.3 versions prior to 20.3R3-S5; 20.4 versions prior to 20.4R3-S5; 21.1 versions prior to 21.1R3-S4; 21.2 versions prior to 21.2R3; 21.3 versions prior to 21.3R3; 21.4 versions prior to 21.4R2. Una vulnerabilidad de Missing Release of Memory after Effective Lifetime en el Flow Processing Daemon (flowd) de Juniper Networks Junos OS permite que un atacante no autenticado basado en la red provoque una denegación de servicio (DoS). • https://kb.juniper.net/JSA70213 • CWE-401: Missing Release of Memory after Effective Lifetime •
CVSS: 5.5EPSS: 0%CPEs: 167EXPL: 0CVE-2023-22409 – Junos OS: SRX Series, MX Series with SPC3: When an inconsistent NAT configuration exists and a specific CLI command is issued the SPC will reboot
https://notcve.org/view.php?id=CVE-2023-22409
An Unchecked Input for Loop Condition vulnerability in a NAT library of Juniper Networks Junos OS allows a local authenticated attacker with low privileges to cause a Denial of Service (DoS). When an inconsistent "deterministic NAT" configuration is present on an SRX, or MX with SPC3 and then a specific CLI command is issued the SPC will crash and restart. Repeated execution of this command will lead to a sustained DoS. Such a configuration is characterized by the total number of port blocks being greater than the total number of hosts. An example for such configuration is: [ services nat source pool TEST-POOL address x.x.x.0/32 to x.x.x.15/32 ] [ services nat source pool TEST-POOL port deterministic block-size 1008 ] [ services nat source pool TEST-POOL port deterministic host address y.y.y.0/24] [ services nat source pool TEST-POOL port deterministic include-boundary-addresses] where according to the following calculation: 65536-1024=64512 (number of usable ports per IP address, implicit) 64512/1008=64 (number of port blocks per Nat IP) x.x.x.0/32 to x.x.x.15/32 = 16 (NAT IP addresses available in NAT pool) total port blocks in NAT Pool = 64 blocks per IP * 16 IPs = 1024 Port blocks host address y.y.y.0/24 = 256 hosts (with include-boundary-addresses) If the port block size is configured to be 4032, then the total port blocks are (64512/4032) * 16 = 256 which is equivalent to the total host addresses of 256, and the issue will not be seen. • https://kb.juniper.net/JSA70205 • CWE-1284: Improper Validation of Specified Quantity in Input •
CVSS: 7.5EPSS: 0%CPEs: 172EXPL: 0CVE-2023-22394 – Junos OS: SRX Series and MX Series: Memory leak due to receipt of specially crafted SIP calls
https://notcve.org/view.php?id=CVE-2023-22394
An Improper Handling of Unexpected Data Type vulnerability in the handling of SIP calls in Juniper Networks Junos OS on SRX Series and MX Series platforms allows an attacker to cause a memory leak leading to Denial of Services (DoS). This issue occurs on all MX Series platforms with MS-MPC or MS-MIC card and all SRX Series platforms where SIP ALG is enabled. Successful exploitation of this vulnerability prevents additional SIP calls and applications from succeeding. The SIP ALG needs to be enabled, either implicitly / by default or by way of configuration. To confirm whether SIP ALG is enabled on SRX use the following command: user@host> show security alg status | match sip SIP : Enabled This issue affects Juniper Networks Junos OS on SRX Series and on MX Series: All versions prior to 19.3R3-S7; 19.4 versions prior to 19.4R2-S8, 19.4R3-S10; 20.1 versions 20.1R1 and later versions; 20.2 versions prior to 20.2R3-S6; 20.3 versions prior to 20.3R3-S6; 20.4 versions prior to 20.4R3-S5; 21.1 versions prior to 21.1R3-S5; 21.2 versions prior to 21.2R3-S1; 21.3 versions prior to 21.3R3; 21.4 versions prior to 21.4R2-S2, 21.4R3; 22.1 versions prior to 22.1R1-S2, 22.1R2, 22.1R3-S1. • https://kb.juniper.net/JSA70190 • CWE-911: Improper Update of Reference Count •